•1 x Protective SKB Case - military-standard waterproof hard case with custom foam (13.5in x 9.5in x 6.5in - 34.29cm x 24.13cm x 16.51cm)
•1 x SDI (BNC to BNC) Cable 10 inch
•1 x HDMI 18in Cable (Type A to Type A)
•2 x Wireless Antennas (2dBi 2.4/5.8GHz) - For Tx
•1 x 2-pin Lemo to PowerTap 18 inch Cable
•1 x Hot Shoe Adapter (1/4"-20 inch)
With highly refined software, new wireless radios, and a redesigned chassis, these new models are the most reliable and capable monitoring solutions we have ever built. Metadata and timecode support, 3D LUTs, dual inputs/outputs, multicast capable, manual frequency selection and USB 3.0 GRAB Engine are all included on these new models but with the following new features:
Transmit visually lossless video up to 1000ft with no delay.
Use more than twice as many Bolts in one location or avoid interference like never before.
2 New DFS Channels
Operate interference-free more often in the USA and Europe by making use of two newly introduced DFS channels.
20% Smaller Chassis
Not just smaller, but lighter too, allowing these models to integrate into any rig unnoticed.
Easily identify which Bolt TX and RX work together with removable colored top plates.
Reconnect times during a dropped link are now instantaneous once you move back into range.
Built-In HDMI to SDI Converter
Perfect for use with MoVI and other gimbals, Bolt’s TX has a built-in HDMI to SDI converter, allowing you to connect both your on-camera monitor and video source via the same device.
More Robust Than Ever Before
Reach your Bolt’s full range and potential right out of the box with new software that provides the most robust wireless link we’ve ever created.
Click on each category to see the relevant tech specs OR click this button:
• 1 x 75 Ohm BNC
• 1 x Type A receptacle HDMI
• 1 x 75 Ohm BNC(Loop-out)
Sdi Ancillary Data Support
• Supports transmitting metadata, timecode, and start/stop flags from certain camera manufacturers. Please refer to: